1999-2008 DODGE/JEEP VEHICLES - Air Temp Sensor 24" Extension Wire

plus $5.00 S&H

Shipping & Handling
(Florida residents, add 7.00% tax)

Updated 3 June, 2021



This Extension Wire will allow you to RE-locate your Air Temperature Sensor to a cooler location WITHOUT the need to cut your harness. Like the POWER WIRE, the EXTENSION WIRE is a PLUG & PLAY mod that leaves your factory harness in-tacked. We use FACTORY STYLE plug connectors for a weather tight seal.

This Intake Air Temp Sensor Extension wire resembles our Popular POWER WIRE and everything is the same except that the EXTENSION WIRE does NOT alter the signal to the PCM... All it does is extend your harness 12"-13".

This is the fix for those who have gone with after market induction systems and found the Air Temp Sensor harness will not reach your new intake. DO NOT CUT YOUR WIRES to extend your plug, just use our extension wire to add an additional 12-13" to your harness.

This wire also gives you the ability to REMOVE it at will with no trace that is was ever installed... This is help full when dealing with your service department.

The POWER WIRE will fit:

  • Fits all 2000-2008 3.7L, 4.7L, 5.7L & 5.9L engines and many other Chrysler vehicles.
  • Works with ANY/ALL stock or aftermarket induction system
  • May also fit many other 2000 to present Dodge vehicles

*NEW* The =EXTENSION=WIRE=> Now installs on these new vehicles:

  • 2005 Dodge Magnum RT
  • 2005 Jeep Grand Cherokee 4.7l
  • 2006 Dodge Charger 3.5L V6
  • Extend your harness 12-24" with factory connectors in your new Dodge/Jeep/Chrysler in little as 1-2 minutes of your time!
  • We will only list them as we learn if they fit or not... If you purchase the Power Wire for your Magnum or Charger or ANY Dodge product and it does NOT fit send it back for a full refund.

EXTENSION/SPLICER (EX-SPLICER) WIRE OPTION This wire is basically an extension wire modified with two exposed leads which allows you to add your own choice of resistance. You could use a resistor or even an adjustable POT resistor simply by tapping into the two exposed leads. You can use this PLUG & PLAY SPLICER wire to relocate your sensor to a cooler location or to make your own "POWER WIRE", its cheaper to use this wire then it is to repair your factory harness. No need to CUT YOUR WIRES to extend your plug. And it allows you the freedom to pick your own resistance for a specific application. This SPLICER WIRE allows you to relocate your sensor without damaging your harness or leaving any trace of modification after removal (Great for when you take it in for service) .
We have many customers who have used this wire to make their own AIT mod. You can add your choice of resistor in-line to gain the desired effect. Modify the cheaper EX-SPLICER WIRE instead of cutting into your expensive harness and damaging your vehicle.