PART #287-2-6125-2007-8740


Shipping & Handling
(Florida residents, add 7.00% tax)

Made to order - Approximate 3-4 month turn time.

These should only be considered if looking to run over 700HP... In most cases the I-beam rods are more than strong enough for the majority of 4.7L builds and are even lighter weight then these H-Beams.

(3-4 month lead time) Performance Rods for the 4.7L engine. We have taken the “Bad Boy” of all SCAT Rods for serious horsepower engines and re-sized them to fit your 4.7L engine. We are proud to bring you these H-Beam rods ready to drop into your 4.7L engine.


We normally have one or two sets of both the ARP8740 and ARP2000 in stock ready to ship but at times there may be a 1-2 week turn time. Contact us if you have any questions on availability.

Our Scat Rods will hold tighter tolerances than +/- .002" per rod width and balance. They will come certified with a balance sheet of BEFORE & AFTER to show there weight.
These are NEW SCAT RODS measure 6.125 in length while the standard 4.7L rods are measure 6.123 long (+ .002) so please contact your engine builder or local machine shop to make sure these will work with your current deck height. This should not make much of a difference but it can increase your CR a hair.

NOT INTENDED FOR USE WITH STOCK PISTON These rods require pistons with a .927 FREE FLOATING wrist pin. Contact us if you have any questions we can suggest a quality Forged Piston to go with these Rods.

Use standard 4.7L TABLESS bearings with these Rods. These are the best H-Beam Rod available ready for high performance 4.7L engines.
These Rods are intended to be used with our Ross Piston sets as a combo. The part number in NOT an actual SCAT Part number and has been changed to reflect resizing. 287-6125-2007.

When Placing PISTON COMBO orders please call to give us specific bore size.

* H-Beam design is the strongest SCAT rod available
* Perfect for supercharged and nitrous applications
* Special doweled cap for specific cap-to-rod alignment
* Profiled clearance for stroker applications

These kits are intended to be BALANCED at your local machine shop, no reason to dump a ton of money into your engine only to skip balancing... this should be done on all built engines. We will do our best to send you a balance assembly but its up to the customer to verify and balance with the crankshaft used in the build up.

Brand: SCAT Engine Components
Product Line: Scat H-Beam Connecting Rods
Part Type: Connecting Rods
Part Number: AIR RAM P/N: 287-2-6125-2007
Connecting Rod Length Center To Center (in): 6.125 in.
Connecting Rod Beam Style: H-beam
Connecting Rod Material: Forged 4340 steel
Wrist Pin Style: Floating
Clearanced for Stroker: Yes
Cap Retention Style: Cap screw
Connecting Rod Bolt Brand: ARP
Connecting Rod Bolt Diameter: 7/16 in.
Connecting Rod Bolt Material: 8740 chromemoly steel
Fastener Yield Strength (psi): 200,000 psi
Connecting Rod Bolt Head Style: 12-point
Big End Bore Diameter (in): Machined to fit standard 4.7L main bearings.
Big End Width (in): Machined down to fit standard 4.7L crank mains.
Weight Matched Set: Yes
Remanufactured: No
Balanced: Yes
Magnafluxed: No
Quantity: Sold as a set of 8.
Custom pistons are required when using connecting rods with any length other than OE length.